JSS1 BASIC TECHNOLOGY SECOND TERM FIRST CONTINUOUS ASSESSMENT TEST (CAT 1)
TIME: 40 minutes
INSTRUCTION: Answer all questions in Sections A and B.
SECTION A: OBJECTIVE TEST
NO. OF QUESTIONS: 20
SPECIFIC INSTRUCTION: Choose the correct answer from the options lettered a – d.
- The two parts of a T-square are the ………… and ………… (a) stock, pin (b) stock, blade (c) pin, handle (d) blade, handle
- All drawing instruments are used for the sole purpose of producing a (a) photo of objects. (b) rough sketch. (c) detailed drawing. (d) sketch drawing.
- The following are grades of pencils used in technical drawing EXCEPT (a) HR. (b) HB. (c) B. (d) H.
- One of these is NOT an angle in the Set-square. (a) 30® (b) 35® (c) 45® (d) 60®
- The reason for using sandpaper as part of the drawing materials is to (a) clean the compass. (b) restore the sharpness of the tip of the edge of pencils. (c) sharpen pencils. (d) keep the drawing board’s surface smooth.
- The language used in technical drawing makes use of the following EXCEPT (a) curves.
You are viewing an excerpt of this lesson. Subscribing to the subject will give you access to the following:
- NEW: Download the entire term's content in MS Word document format (1-year plan only)
- The complete lesson note and evaluation questions for this topic
- The complete lessons for the subject and class (First Term, Second Term & Third Term)
- Media-rich, interactive and gamified content
- End-of-lesson objective questions with detailed explanations to force mastery of content
- Simulated termly preparatory examination questions
- Discussion boards on all lessons and subjects
- Guaranteed learning